D-Link DES-3550 - Link Aggregation Commands

DES-3550 Layer 2 Fast Ethernet Switch
17
LINK AGGREGATION COMMANDS
The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create link_aggregation group_id <value 1-6> {type [lacp | static]}
delete link_aggregation group_id <value 1-6>
config link_aggregation group_id <value1-6> {master_port <port> | ports <portlist>
state [enable | disable]}
config link_aggregation
algorithm
[mac_source | mac_destination | mac_source_dest | ip_source
| ip_destination | ip_source_dest]
show link_aggregation {group_id <value 1-6> | algorithm}
config lacp_port <portlist> mode [active | passive]
show lacp_port {<portlist>}
Each command is listed, in detail, in the following sections.
150