D-Link DES-3550 - Commands

DES-3550 Layer 2 Fast Ethernet Switch
22
802.1X COMMANDS
The DES-3550 implements the server-side of the IEEE 802.1x Port-based and MAC-based Network Access Control. This
mechanism is intended to allow only authorized users, or other network devices, access to network resources by establishing
criteria for each port on the Switch that a user or network device must meet before allowing that port to forward or receive
frames.
Command Parameters
enable 802.1x
disable 802.1x
show 802.1x
auth_state
{ports <portlist>}
show 802.1x
auth_configuration
{ports <portlist>}
config 802.1x
capability ports
[<portlist> | all] [authenticator | none]
config 802.1x
auth_parameter
ports
[<portlist> | all] [default | {direction [both | in] | port_control
[force_unauth | auto | force_auth] | quiet_period <sec 0-65535> |
tx_period <sec 1-65535> | supp_timeout <sec 1-65535> |
server_timeout <sec 1-65535> | max_req <value 1-10> |
reauth_period <sec 1-65535> | enable_reauth [enable | disable]}]
config 802.1x
auth_protocol
[radius eap | radius pap]
config 802.1x init
[port_based | mac_based]
{port_based ports [<portlist> | all] | mac_based [ports] [<portlist>
|all] {mac_address <macaddr>}]
<server_index 1-3> <server_ip> key <passwd 32> [default |
{auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
<server_index 1-3>
<server_index 1-3> {ipaddress <server_ip> | key <passwd 32>
[auth_port <udp_port_number 1-65535> acct_port
<udp_port_number 1-65535>]}
{port_based ports [<portlist> | all] | mac_based [ports] [<portlist>
|all] {mac_address <macaddr>}]
config 802.1x
auth_mode
config 802.1x
reauth
config radius add
config radius delete
config radius
show radius
Each command is listed, in detail, in the following sections.
184