D-Link DES-3550 - Page 189

DES-3550 Layer 2 Fast Ethernet Switch
enable 802.1x
Purpose Used to enable the 802.1x server on the Switch.
Syntax
enable 802.1x
The enable 802.1x command enables the 802.1x Network Access control
server application on the Switch. To select between port-based or MAC-
based, use the config 802.1x auth_mode command.
Only administrator-level users can issue this command.
Description
Parameters None.
Restrictions
Example usage:
Command: enable 802.1x
To enable 802.1x switch wide:
DES-3550:4#enable 802.1x
Success.
DES-3550:4#
disable 802.1x
Purpose Used to disable the 802.1x server on the Switch.
Syntax
disable 802.1x
Description
The disable 802.1x command is used to disable the 802.1x Network Access
control server application on the Switch. To select between port-based or
MAC-based, use the config 802.1x auth_mode command.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
DES-3550:4#
To disable 802.1x on the Switch:
DES-3550:4#disable 802.1x
Command: disable 802.1x
Success.
185