DES-3550 Layer 2 Fast Ethernet Switch
8
SWITCH UTILITY COMMANDS
The download/upload commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
download
[ firmware <ipaddr> <path_filename 64> {section_id <int 1-2>}
configuration <ipaddr> <path_filename 64> {increment} ]
config firmware image_id <value 1-2> [delete | boot_up]
show firmware_information
show config [ current_config | config_in_nvram ]
upload
[ configuration | log ] <ipaddr> <path_filename 64>
enable autoconfig
disable autoconfig
show autoconfig
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
Each command is listed, in detail, in the following sections.
62
To Next Page
Loading...
