DES-3550 Layer 2 Fast Ethernet Switch
5
SWITCH PORT COMMANDS
The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config ports
[<portlist
| all> {speed [auto | 10_half | 10_full |100_half | 100_full | 1000_full} | flow_control [enable | disable] | learning [enable |
disable] state [enable | disable]} description <desc 32>
show ports
<portlist> {description}
Each command is listed, in detail, in the following sections.
25
To Next Page
Loading...
