DES-3550 Layer 2 Fast Ethernet Switch
config traffic control
Purpose Used to configure broadcast/multicast traffic control.
Syntax
config traffic control [<storm_grouplist> | all] broadcast [enable
| disable] | multicast [enable | disable] | dlf [enable | disable] |
threshold <value 0-255>
Description This command is used to configure broadcast storm control.
Parameters
<storm_grouplist> − Used to specify a broadcast storm control
group. This is specified by entering the syntax unit_id.
all − Specifies all broadcast storm control groups on the Switch.
broadcast [enable | disable] − Enables or disables broadcast storm
control.
multicast [enable | disable] − Enables or disables multicast storm
control.
dlf [enable | disable] − Enables or disables dlf traffic control.
threshold <value 0-255> − The upper threshold at which the
specified traffic control is switched on. The <value> is the number of
broadcast/multicast/dlf packets, in Kpps, received by the Switch that
will trigger the storm traffic control measures.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure traffic control and enable broadcast storm control system wide:
DES-3550:4#config traffic control all broadcast enable
Command: config traffic control all broadcast enable
Success.
DES-3550:4#
122
To Next Page
Loading...
