D-Link DES-3550 - Page 130

DES-3550 Layer 2 Fast Ethernet Switch
show bandwidth_control
Purpose Used to display the bandwidth control table.
Syntax
show bandwidth_control {<portlist>}
Description
The show bandwidth_control command displays the current
bandwidth control configuration on the Switch, on a port-by-port
basis.
Parameters
<portlist> − Specifies a port or range of ports to be viewed.
Restrictions None.
Example usage:
To display bandwidth control settings:
DES-3550:4#show bandwidth_control 1-10
Command: show bandwidth_control 1-10
Bandwidth Control Table
Port RX Rate (Mbit/sec) TX_RATE (Mbit/sec)
---- ------------------------ ----------------------
1 no_limit 10
2 no_limit 10
3 no_limit 10
4 no_limit 10
5 no_limit 10
6 no_limit 10
7 no_limit 10
8 no_limit 10
9 no_limit 10
10 no_limit 10
DES-3550:4#
126