DES-3550 Layer 2 Fast Ethernet Switch
show 802.1x auth_state
Purpose Used to display the current authentication state of the 802.1x server on the Switch.
Syntax
show
802.1x auth_state {ports <portlist>}
Description The show 802.1x auth_state command is used to display the current authentication state
of the 802.1x Port-based and MAC-based Network Access Control server application on
the Switch.
Parameters
ports <portlist> − Specifies a port or range of ports to be viewed.
The following details what is displayed:
Port number − Shows the physical port number on the Switch.
Auth PAE State: Initalize / Disconnected / Connecting / Authenticating / Authenticated /
Held / ForceAuth / ForceUnauth − Shows the current state of the Authenticator PAE.
Backend State: Request / Response / Fail / Idle / Initalize / Success / Timeout − Shows
the current state of the Backend Authenticator.
Port Status: Authorized / Unauthorized − Shows the result of the authentication process.
Authorized means that the user was authenticated, and can access the network.
Unauthorized means that the user was not authenticated, and cannot access the
network.
Restrictions Only administrator-level users can issue this command.
188
To Next Page
Loading...
