DES-3550 Layer 2 Fast Ethernet Switch
config 802.1x auth_mode
Purpose Used to configure the 802.1x authentication mode on the Switch.
Syntax
config 802.1x auth_mode {port_based | mac_based]
Description The config 802.1x authentication mode command is used to enable
either the port-based or MAC-based 802.1x authentication feature
on the Switch.
Parameters
[port_based | mac_based ports] − The Switch allows you to
authenticate 802.1x by either port or MAC address.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x authentication by MAC address:
DES-3550:4#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DES-3550:4#
191
To Next Page
Loading...
