DES-3550 Layer 2 Fast Ethernet Switch
config 802.1x reauth
Purpose Used to configure the 802.1x re-authentication feature of the Switch.
Syntax
config 802.1x reauth {port_based ports [<portlist> | all] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr>}]
Description The config 802.1x reauth command is used to re-authenticate a
previously authenticated device based on port number.
Parameters port_based – This instructs the Switch to re-authorize 802.1x functions
based only on the port number. Ports approved for re-authorization
can then be specified.
mac_based − This instructs the Switch to re-authorize 802.1x functions
based only on the MAC address. MAC addresses approved for re-
authorization can then be specified.
ports <portlist> − Specifies a port or range of ports to be re-authorized.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> - Enter the MAC address to be re-
authorized.
Restrictions Only administrator-level users can issue this command.
Example usage:
Command: config 802.1x reauth port_based ports 1-18
To configure 802.1x reauthentication for ports 1-18:
DES-3550:4#config 802.1x reauth port_based ports 1-18
Success.
DES-3550:4#
196
To Next Page
Loading...
