DES-3550 Layer 2 Fast Ethernet Switch
create access_profile
packet_content_mask – Specifies that the Switch will mask the packet header beginning with the
offset value specified as follows:
•
•
•
•
•
profile_id <value 1-255> − Sets the relative priority for the profile. Priority is set relative to other
profiles where the lowest profile ID has the highest priority.
Parameters
Restrictions
offset_0-15 – Enter a value in hex form to mask the packet from the beginning of the packet
to the 16
th
byte.
offset_16-31 – Enter a value in hex form to mask the packet from byte 16 to byte 31.
offset_32-47 – Enter a value in hex form to mask the packet from byte 32 to byte 47.
offset_48-63 – Enter a value in hex form to mask the packet from byte 48 to byte 63.
offset_64-79 – Enter a value in hex form to mask the packet from byte 64 to byte 79.
Only administrator-level users can issue this command.
Example usage:
To create an access list rules:
DES-3550:4#create access_profile ip vlan source_ip_mask 20.0.0.0
destination_ip_mask 10.0.0.0 dscp icmp type code permit profile_id 101
Command: create access_profile ip vlan source_ip_mask 20.0.0.0
destination_ip_mask 10.0.0.0 dscp icmp type code permit profile_id 101
Success.
DES-3550:4#
206
To Next Page
Loading...
