DES-3550 Layer 2 Fast Ethernet Switch
create iproute default
Purpose Used to create IP route entries to the Switch’s IP routing table.
Syntax
create iproute [default] <ipaddr> {<metric 1-65535>}
Description This command is used to create a default static IP route entry to the
Switch’s IP routing table.
Parameters
<ipaddr> − The gateway IP address for the next hop router.
<metric 1-65535> − Allows the entry of a routing protocol metric entry
representing the number of routers between the Switch and the IP
address above. The default setting is 1.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To add the default static address 10.48.74.121, with a metric setting of 1, to the routing table:
DES-3550:4#create iproute default 10.48.74.121 1
Command: create iproute default 10.48.74.121 1
Success.
DES-3550:4#
238
To Next Page
Loading...
