DES-3550 Layer 2 Fast Ethernet Switch
create syslog host
Parameters
local0 − Specifies that local use 0 messages will be sent to the remote host. This corresponds
to number 16 from the list above.
local1 − Specifies that local use 1 messages will be sent to the remote host. This corresponds
to number 17 from the list above.
local2 − Specifies that local use 2 messages will be sent to the remote host. This corresponds
to number 18 from the list above.
local3 − Specifies that local use 3 messages will be sent to the remote host. This corresponds
to number 19 from the list above.
local4 − Specifies that local use 4 messages will be sent to the remote host. This corresponds
to number 20 from the list above.
local5 − Specifies that local use 5 messages will be sent to the remote host. This corresponds
to number 21 from the list above.
local6 − Specifies that local use 6 messages will be sent to the remote host. This corresponds
to number 22 from the list above.
local7 − Specifies that local use 7 messages will be sent to the remote host. This corresponds
to number 23 from the list above.
udp_port <udp_port_number> − Specifies the UDP port number that the syslog protocol will use
to send messages to the remote host.
state [enable | disable] − Allows the sending of syslog messages to the remote host, specified
above, to be enabled and disabled.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To create syslog host:
DES-3550:4#create syslog host 1 severity all facility local0
Command: create syslog host 1 severity all facility local0
Success.
DES-3550:4#
85
To Next Page
Loading...
