The Switch is equipped with SFP ports, which are to be used with fiber-optical transceiver cabling in order to
uplink various other networking devices for a gigabit link that may span great distances.
Conncting the DPS-200 to the RPS Port (for DGS-1210-10/ME only)
The DPS-200 redundant power supply can be connected to the RPS port of the Switch using the DC power
supply cord, called the DPS-CB150-2PS. It is important to notice that the DPS-200 can supply power to one
or two DGS-1210-10/ME at the same time.
Figure 1.15 – Connecting two Switches to the DPS-200
The following section explaines how to connect the DPS-200 to the Switch.
Disconnect the Switch from the main AC power source.
Insert the 14-pin end of the DPS-CB150-2PS into the DPS-200 and the 2-pin end into the receptacle
of the RPS port on the Switch.
Using a standard AC power cord, connect the DPS-200 to the main AC power source. A green LED
on the front panel of the DPS-200 will illuminate to indicate a successful connection.
Make sure that the ON/OFF toggle switch on the rear panel of the Switch is turned on.
Re-connect the Switch to the AC power source and power on the DPS-200.
No configuration is needed in the Switch software for this installation.
Installing the RPS into a Rack-mount Chassis (for DGS-1210-10/ME only)
The DPS-200 is the redundant power supply unit designed to conform to the voltage requirements of the
RPS port of the Switch being supported. The DPS-200 can be installed into a DPS-800 and a DPS-900 rack-
mount chassis unit.
CAUTION: DO NOT connect the RPS to the AC power before the DC
power cable is connected. Connecting the AC power before the DC
power is connected might damage the internal power supply.
DPS-800 Rack-mount Chassis
The DPS-800 is a standard-size rack-mount (1 standard unit in height) designed to hold up to two DPS-200
redundant power supplies.
To Next Page
Loading...
