DGS-1210/ME series Metro Ethernet Switch Hardware Installation Guide
22
4 Web-based Switch Configuration
Logging onto the Web Manager
Web-based User Interface
Areas of the User Interface
Web Pages
Logging onto the Web Manager
In order to login and configure the switch via an Ethernet connection, the PC must have an IP address in the
same subnet as the switch. For example, if the switch has an IP address of 10.90.90.90, the PC should have
an IP address of 10.x.y.z (where x/y is a number between 0 ~ 254 and z is a number between 1 ~ 254), and
a subnet mask of 255.0.0.0. Enter 10.90.90.90 (the factory default IP address) in the address bar of your
web browser and press <Enter>.
Figure 4.1 –Enter the IP address 10.90.90.90 in the web browser
NOTE: The switch's factory default IP address is
10.90.90.90 with a subnet mask of 255.0.0.0 and
a default gateway of 0.0.0.0.
When the following logon dialog box appears, enter the password and choose the language of the Web-
based Management interface then click OK.
By default, the Username and Password are empty.
Figure 4.2 – Logon Dialog Box
Web-based User Interface
The user interface provides access to various Switch configuration and management windows, it allows the
user to view performance statistics, and permits graphical monitoring of the system status.
Areas of the User Interface
The figure below shows the user interface. Three distinct areas divide the user interface, as described in the
table.
To Next Page
Loading...
