xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1113
ipif-name: Name of the DHCPv6 client interface.
Event description: DHCPv6 relay on a specify interface’s
administrator state changed
Log Message: DHCPv6 relay on interface <ipif-name> changed
state to [enabled | disabled]
Parameters description:
<ipif-name>: Name of the DHCPv6 relay agent interface.
Event description: The address of the DHCPv6 Server pool is
used up
Log Message: The address of the DHCPv6 Server pool <pool-
name> is used up.
Parameters description:
<pool-name>: Name of the DHCPv6 Server pool.
Event description: The number of allocated ipv6 addresses is
equal to 4096
Log Message: The number of allocated ipv6 addresses of the
DHCPv6 Server pool is equal to 4096.
Parameters description:
Event description: IP Directed-broadcast rate exceed 50
packets per second on a certain subnet.
Log Message: IP Directed Broadcast packet rate is high on
subnet. [(IP: %s)]
Parameters description:
IP: the Broadcast IP destination address.
Event description: IP Directed-broadcast rate exceed 100
packets per second
Log Message: IP Directed Broadcast rate is high.
Parameters description:
Event description: Firmware upgraded successfully.
Log Message: [RCP(1):] [Unit <unitID>,] Firmware upgraded by
<session> successfully. (Username: <username>, IP: <ipaddr>,
MAC: <macaddr>)
Parameters description:
unitID: Represent the id of the device in the stacking system.
session: The user’s session.
username: Represent current login user.
ipaddr: Represent client IP address.
macaddr : Represent client MAC address.
Event description: Firmware upgrade unsuccessfully.
Log Message: [RCP(2):] [Unit <unitID>,] Firmware upgrade by
To Next Page
Loading...
