D-Link DGS-3620-52P - Page 295

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
290
Format
debug ospf show flag
Parameters
None.
Restrictions
Only Administrator level users can issue this command.
Example
To show the current OSPF debug flag setting:
DGS-3620-28SC:admin# debug ospf show flag
Command: debug ospf show flag
Global State: Enabled
Current OSPF Flags Setting:
Neighbor State Change
Interface State Change
LSA Originating
LSA Operating
LSA Receiving
LSA Flooding
Packet Receiving
Packet Sending
Retransmission
Timer
DR Selection
Route
Redistribution
Virtual Link
SPF Intra
SPF Inter
SPF Extern
DGS-3620-28SC:admin#
20-25 debug ospf show log state
Description
This command is used to display the OSPF debug log state.