xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
419
Parameters
trap - Specifies to enable or disable the ERPS trap state.
enable - Enter enable to enable the trap state.
disable - Enter disable to disable the trap state. The default value is disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the trap state of the ERPS:
DGS-3620-28SC:admin# config erps trap enable
Command: config erps trap enable
Success.
DGS-3620-28SC:admin#
31-8 show erps
Description
This command is used to display ERPS configuration and operation information. The port state of
the ring port may be as Forwarding, Blocking, or Signal Fail. Forwarding indicates that traffic is
able to be forwarded. Blocking indicates that traffic is blocked by ERPS and a signal failure is not
detected on the port. Signal Fail indicates that a signal failure is detected on the port and traffic is
blocked by ERPS.
Format
show erps {raps_vlan <vlanid> {sub_ring}}
Parameters
raps_vlan - Specifies the R-APS VLAN.
<vlanid> - Enter the R-APS VLAN ID used here.
sub_ring - Display the sub-ring configuration information.
Restrictions
None.
Example
To display ERPS information:
To Next Page
Loading...
