D-Link DGS-3620-52P - Page 549

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
544
DGS-3620-28SC:admin#enable address_binding dhcp_snoop
Command: enable address_binding dhcp_snoop
Success.
DGS-3620-28SC:admin#
46-14 disable address_binding dhcp_snoop
Description
This command is used to disable address binding DHCP snooping. When DHCP snooping is
disabled, all of the auto-learned binding entries will be removed.
Format
disable address_binding dhcp_snoop {[ipv6 | all]}
Parameters
ipv6 – (Optional) Specifies that the address used is an IPv6 address.
all – Specifies that all IP addresses will be used.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable the address binding DHCP snooping mode:
DGS-3620-28SC:admin#disable address_binding dhcp_snoop
Command: disable address_binding dhcp_snoop
Success.
DGS-3620-28SC:admin#
46-15 clear address_binding dhcp_snoop binding_entry ports
Description
This command is used to clear the address binding entries learned for the specified ports.
Format
clear address_binding dhcp_snoop binding_entry ports [<portlist> | all] {[ipv6 | all]}
Parameters
<portlist> - Specify the list of ports to clear the DHCP-snoop learned entry.
all - Specify to clear the address binding entries learned for all ports.