D-Link DGS-3620-52P - Page 550

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
545
ipv6 – (Optional) Specifies that the address used is an IPv6 address.
all – Specifies that all IPv6 addresses will be used.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To clear the address binding entries for ports 1 to 3:
DGS-3620-28SC:admin# clear address_binding dhcp_snoop binding_entry ports 1-3
Command: clear address_binding dhcp_snoop binding_entry ports 1-3
Success.
DGS-3620-28SC:admin#
46-16 show address_binding dhcp_snoop
Description
This command is used to display DHCP snooping information.
Format
show address_binding dhcp_snoop {max_entry {ports <portlist>}}
Parameters
max_entry - (Optional) Specify to display the maximum number of entries.
ports - (Optional) Specify a range of ports.
<portlist> - Specify a range of ports to be displayed.
Restrictions
None.
Example
To display address binding DHCP snooping:
DGS-3620-28SC:admin#show address_binding dhcp_snoop
Command: show address_binding dhcp_snoop
DHCP Snoop(IPv4) : Disabled
DHCP Snoop(IPv6) : Disabled
DGS-3620-28SC:admin#
To display the address binding DHCP snooping maximum entries on port 1 to 10:
DGS-3620-28SC:admin#show address_binding dhcp_snoop max_entry ports 1-10