D-Link DGS-3620-52P - Page 725

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
720
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To disable SNMP linkchange trap support:
DGS-3620-28SC:admin#disable snmp linkchange_traps
Command: disable snmp linkchange_traps
Success.
DGS-3620-28SC:admin#
66-16 config snmp linkchange_traps ports
Description
This command is used to configure the sending of linkchange traps and per port control for
sending of change traps.
Format
config snmp linkchange_traps ports [all | <portlist>] [enable | disable]
Parameters
all - Specify all ports.
<portlist> - Specify a port or range of ports.
enable - Enable sending of the link change trap for this port.
disable - Disable sending of the link change trap for this port.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable SNMP linkchange traps for ports 1 to 4:
DGS-3620-28SC:admin#config snmp linkchange_traps ports 1-4 enable
Command: config snmp linkchange_traps ports 1-4 enable
Success.
DGS-3620-28SC:admin#