22D-Link DIR-820L User Manual
Select Dynamic IP (DHCP) to obtain IP Address information
automatically from your ISP. Select this option if your ISP does not
give you any IP numbers to use. This option is commonly used for
cable modem services.
The Host Name is optional but may be required by some ISPs. Leave
blank if you are not sure.
Check the box if you are having problems obtaining an IP address
from your ISP.
Enter the Primary and Secondary DNS server IP addresses assigned by
your ISP. These addresses are usually obtained automatically from your
ISP. Leave blank if you did not specically receive these from your ISP.
Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your specic ISP. 1500 is the default MTU.
The default MAC Address is set to the Internet port’s physical interface
MAC address on the Broadband Router. It is not recommended that
you change the default MAC address unless required by your ISP.
You can use the Copy Your PC’s MAC Address button to replace the Internet port’s MAC address with the MAC address of your
Ethernet card.
My Internet
Connection:
Host Name:
MAC Address:
Internet Setup
Dynamic (Cable)
Primary/Secondary
DNS Server:
MTU:
Use Unicasting:
To Next Page
Loading...
