D-Link DIR-820L - Ipv6 Firewall

88D-Link DIR-820L User Manual
IPv6 Firewall
The DIR-820L’s IPv6 Firewall feature allows you to congure which kind of IPv6 trac is allowed to pass through the device.
This feature functions in a similar way to the IP Filters feature.
Enable IPv6 Ingress
Filtering:
Enable IPv6 Simple
Security:
Congure IPv6 rewall
below:
Name:
Schedule:
Source:
Dest:
IP Address Range:
Protocol:
Port Range:
TBD
Check the box to enable the IPv6 rewall simple security.
Select one of the following options:
Turn IPv6 rewall o
Turn IPv6 Firewall ON and ALLOW Rules listed
Turn IPv6 Firewall ON and DENY Rules listed
Enter a name to identify the IPv6 rewall rule.
The schedule for when the IPv6 Firewall Rules will be enabled may be
set to Always or Never. Or you can create your own schedule in the
Tools > Schedules section.
Use the Interface drop-down menu to specify the interface that
connects to the source IPv6 addresses of the rewall rule.
Use the Interface drop-down menu to specify the interface that
connects to the destination IP address of the rewall rule.
Enter the Source IPv6 address range in the adjacent IP Address Range
eld, and enter the Dest IPv6 address range in the other IP Address
Range eld below.
Select the protocol of the rewall port (Any, TCP, UDP, or ICMP).
Enter the rst port of the range that will be used for the rewall rule
in the rst box and enter the last port in the range in the second box.