D-Link Dis-200G Series

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
98
20-4 show lldp neighbor interface
This command is used to display each physical interface’s information currently learned from the
neighbor.
show lldp neighbors interface INTERFACE-ID [, | -] brief
Parameters
INTERFACE-ID
Specifies the interface ID.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
-
(Optional) Specifies a range of interfaces. No spaces before and
after the hyphen.
brief
(Optional) Specifies to display the information in brief mode.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command display the information learned from the neighbor devices.
Example
This example shows how to display the neighbor information on Ethernet 1/0/1 to Ethernet 1/0/2 in brief mode.
Switch# show lldp neighbors interface Ethernet 1/0/1-2 brief
Port ID: eth1/0/1
------------------------------------------------------------
Remote Entities Count : 2
Entity 1
Chassis ID Subtype : MAC Address
Chassis ID : 00-01-02-03-04-01
Port ID Subtype : Local
Port ID : eth1/0/1
Port Description : RMON Port 1 on Unit 3
Entity 2
Chassis ID Subtype : MAC Address
Chassis ID : 00-01-02-03-04-02
Port ID Subtype : Local
Port ID : eth1/0/1