To Next Page

To Previous Page

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide

231

43. Virtual LAN (VLAN) Commands

43-1

acceptable-frame

This command is used to set the acceptable types of frames by a port. Use the

form of this command to

revert to the default settings.

acceptable-frame {tagged-only | untagged-only | admit-all}

no acceptable-frame

Parameters

tagged-only

Specifies that only tagged frames are admitted.

untagged-only

Specifies that only untagged frames are admitted.

admit-all

Specifies that all frames are admitted.

Default

For the access VLAN mode, the default option is untagged-only.

For the other VLAN mode, the default option is admit-all.

Command Mode

Interface Configuration Mode.

Command Default Level

Level: 15.

Usage Guideline

This command is used to set the acceptable types of frames by a port.

Example

This example shows how to set the acceptable frame type to tagged-only for port eth1/0/2.

Switch# configure terminal

Switch(config)# interface Ethernet 1/0/2

Switch(config-if)# acceptable-frame tagged-only

Switch(config-if)#

D-Link Dis-200G Series User Manual

Other manuals for D-Link Dis-200G Series