D-Link Dis-200G Series User Manual

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
162
32. Simple Network Management
Protocol(SNMP) Commands
32-1 show snmp-server
This command is used to display the SNMP server’s global state settings and trap related settings.
show snmp-server [traps]
Parameters
traps
(Optional) Specifies to display trap related settings.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use the show snmp-server command to display the SNMP server global state settings. Use the show snmp-
server traps command to display trap related settings.
Example
This example shows how to display the SNMP server configuration.
Switch# show snmp-server
SNMP Server : Enabled
Name : SiteA-Switch
Location : HQ 15F
Contact : MIS Department II
Switch#
This example shows how to display trap related settings.
Switch# show snmp-server traps
Global Trap State : Enabled
Individual Trap State:
Authentication : Enabled
linkup : Enabled
linkdown : Enabled
coldstart : Enabled

D-Link Dis-200G Series Specifications

General

Brand	D-Link
Model	Dis-200G Series
Category	Switch
Language	English