D-Link Dis-200G Series User Manual

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
69
14. GARP VLAN Registration Protocol (GVRP)
Commands
14-1 gvrp global
This command is used to enable the GVRP function globally. Use the no form of this command to disable the
GVRP function globally.
gvrp global
no gvrp global
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is available for both physical ports and port-channel interface configuration. This command only
takes effect for hybrid mode and trunk mode.
Example
This example shows how to enable the GVRP function on interface eth1/0/1.
Switch# configure terminal
Switch(config)# gvrp global
Switch(config)#
14-2 gvrp enable
This command is used to enable the GVRP function on a port. Use the no form of this command to disable the
GVRP function on a port.
gvrp enable
no gvrp enable
Parameters
None.
Default
By default, this option is disabled.

D-Link Dis-200G Series Specifications

General

Brand	D-Link
Model	Dis-200G Series
Category	Switch
Language	English