D-Link Dis-200G Series

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
214
38. System Log Commands
38-1 clear logging
This command is used to delete log messages.
clear logging
Parameters
None.
Default
None.
Command Mode
Privilege EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
This command deletes all the log messages in the system.
Example
This example shows how to delete all the log messages in the system.
Switch# clear logging
Switch#
38-2 logging buffered
This command is used to enable logging of system messages. Use the no form of this command to disable the
logging of messages.
logging buffered
Parameters
none
Default
By default, the logging buffered is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline