D-Link Dis-200G Series

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
125
Example
This example shows how to display the PoE power system’s power information.
Switch# show poe power module
Unit Delivered(W) Power Budget(W) Usage-Threshold(%) Trap State
-------------------------------------------------------------------
1 0.0 40.0 50 Disabled
Switch#
Display Parameters
Unit
The unit ID of stacking device.
Delivered
The actual amount of power delivered to the PD in watts.
Power budget
The total power can be provided by the device in watts.
Usage-Threshold
The utilization threshold to record a log.
Trap state
enabled - send trap if reach utilication threshold.
25-6 poe pd alive
This command is used to enable the PD alive check function for the PD connected to the PoE port. Use the no
form of this command to disable the function.
poe pd alive [{ip IP-ADDRESS | interval INTERVAL-TIME | retry RETRY-COUNT | waiting-time
WAITING-TIME | action {reset | notify | both}}]
no poe pd alive [{ip | interval | retry | waiting-time | action}]
Parameters
Ip IP-ADDRESS
(Optional) Specifies the IPv4 address of the target PD for the
system executing the ping action.
IP-ADDRESS - Specifies the IPv4 address of the target PD.
Interval INTERVAL-TIME
(Optional) Specifies the interval for the system to issue ping
requests to detect the target PD. The valid range is from 10 to 300
seconds.
retry RETRY-COUNT
(Optional) Specifies the retry counts of ping requests when PD has
no response. The valid range is from 0 to 5.
waiting-time WAITING-TIME
(Optional) Specifies the waiting time for PD to recover from
rebooting. The valid range is from 30 to 300 seconds.
action
(Optional) Specifies the action of the system when PD does not