D-Link Dis-200G Series User Manual

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
159
30-9 snmp-server enable traps rmon
This command is used to enable the RMON trap state.
snmp-server enable traps rmon [rising-alarm | falling-alarm]
no snmp-server enable traps rmon [rising-alarm | falling-alarm]
Parameters
rising-alarm
(Optional) Specifies to configure the rising alarm trap state.
falling-alarm
(Optional) Specifies to configure the falling alarm trap state.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command enables RMON trap state.
Example
This example shows how to enable the sending of RMON traps for both the falling alarm and rising alarm.
Switch# configure terminal
Switch(config)# snmp-server enable traps rmon
Switch(config)#

D-Link Dis-200G Series Specifications

General

Brand	D-Link
Model	Dis-200G Series
Category	Switch
Language	English