D-Link Dis-200G Series User Manual

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
191
Example
This example shows how to enable the surveillance VLAN function and configure VLAN 1001 as a Surveillance
VLAN.
Switch# config terminal
Switch(config)# surveillance vlan 1001
Switch(config)#
35-2 surveillance vlan aging
This command is used to configure the aging time for aging out the surveillance VLAN dynamic member ports.
Use the
no form of this command to revert to the default setting.
surveillance vlan aging MINUTES
no surveillance vlan aging
Parameters
MINUTES
Specifies the aging time of surveillance VLAN. The range is from 1
to 65535 minutes.
Default
By default, this aging time is 720 minutes.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to configure the aging time for aging out the surveillance device and the surveillance VLAN
automatically learned member ports.
When the last surveillance device connected to the port stops sending traffic, and the MAC address of this
surveillance device is aged out, the surveillance VLAN aging timer will be started. The port will be removed
from the surveillance VLAN after expiration of surveillance VLAN aging timer.
If the surveillance traffic resumes during the aging time, the aging timer will be cancelled.
Example
This example shows how to configure the aging time of surveillance VLAN to 30 minutes.
Switch# config terminal
Switch(config)# surveillance vlan aging 30
Switch(config)#
35-3 surveillance vlan enable

D-Link Dis-200G Series Specifications

General

Brand	D-Link
Model	Dis-200G Series
Category	Switch
Language	English