D-Link Dis-200G Series

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
198
Parameters
device
Specifies to display the learned surveillance devices information.
interface
(Optional) Specifies to display surveillance VLAN information of
ports.
INTERFACE-ID
(Optional) Specifies the port to be displayed.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
-
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the surveillance VLAN configurations.
The
show surveillance vlan command is used to display the surveillance VLAN global configurations.
The
show surveillance vlan interface command is used to display the surveillance vlan configurations on the
interfaces.
The show surveillance vlan device command is used to display the surveillance device discovered by its
OUI.
Example
This example shows how to display the surveillance VLAN global settings.
Switch# show surveillance vlan
Surveillance VLAN ID : 100
Surveillance VLAN CoS : 5
Aging Time : 30 minutes
ONVIF Discover Port : 554
Log State : Enabled
Member Ports :
Dynamic Member Ports :
Surveillance VLAN OUI :
OUI Address Mask Component Type Description
----------------- ----------------- --------------- --------------
28-10-7B-00-00-00 FF-FF-FF-E0-00-00 D-Link Device IP Surveillance Device
28-10-7B-20-00-00 FF-FF-FF-F0-00-00 D-Link Device IP Surveillance Device