D-Link Dis-200G Series

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
201
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display ONVIF-based NVR and group information. The group ID is the group ID of
the IPCs that belong to the NVR group. NVRs and IPCs, managed by it, must have the same group ID.
Example
This example shows how to display ONVIF-based NVR information.
Switch# show surveillance vlan onvif-nvr interface Ethernet 1/0/1
Interface : eth1/0/1
IP Address : 111.111.111.111
MAC Address : 00-01-02-03-04-08
IPC Number : 2
Manufacturer : D-Link
Group : Group 1
Description : D-Link-NVR
Total Entries: 1
Switch#
This example shows how to display ONVIF-based NVR information associated with the group ID 'ipc-list'.
Switch# show surveillance vlan onvif- nvr interface Ethernet 1/0/1 ipc-list
Interface IP address MAC address Group Description
-------------- ----------------- -------------------- -------- -----------------
1 10.90.90.90 00-01-02-03-04-05 1 D-Link-IPC-1
1 10.90.90.100 00-01-02-03-04-06 1 D-Link-IPC-2
Total Entries : 2
Switch#