D-Link Dis-200G Series

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
243
function.
Example
This example shows how to enable the voice VLAN function on the physical port eth1/0/1.
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/1
Switch(config-if)# voice vlan enable
Switch(config-if)#
44-4 voice vlan mac-address
This command is used to add the user-defined voice device OUI. Use the no form of this command to delete
the user-defined voice device OUI.
voice vlan mac-address MAC-ADDRESS MASK [description TEXT ]
no voice vlan mac-address
MAC-ADDRESS MASK
Parameters
MAC-ADDRES
Specifies the OUI MAC address.
MASK
Specifies the OUI MAC address matching bitmask.
description TEXT
(Optional) Specifies the description for the user defined OUI with a
maximum of 32 characters.
Default
The default OUI is listed in the following table:
OUI
Vendor
00:E0:BB
3COM
00:03:6B
Cisco
00:E0:75
Veritel
00:D0:1E
Pingtel
00:01:E3
Siemens
00:60:B9
NEC/Philips
00:0F:E2
Huawei-3COM
00:09:6E
Avaya
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.