D-Link Dis-200G Series

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
39
low
Specifies that when the operating parameter falls below this low
threshold value, it indicates an abnormal status.
alarm
Specifies to configure the high and low threshold value condition.
warning
Specifies to configure the high and low warning threshold
conditions.
VALUE
Specifies the threshold value. This value must be between 0 and
6.55 Volt.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Only SFP/SFP+ port interfaces with optical modules, with transceiver monitoring capability, are valid for this
onfiguration.
The no form of this command has the effect to clear the configured threshold stored in system.
Example
This example shows how to configure the low alarm voltage threshold as 0.005 on interface eth1/0/11.
Switch# configure terminal
Switch(config)# transceiver-monitoring voltage Ethernet 1/0/11 low alarm 0.005
Switch(config)#