D-Link Dis-200G Series

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
51
11-8 profile
This command is used to associate an ERP instance with a G.8032 profile. Use the no form of this command to
remove the association.
profile PROFILE-NAME
no profile
PROFILE-NAME
Parameters
PROFILE-NAME
Specifies the profile name to be associated with the ERP instance.
Default
None.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is used to associate an ERP instance with a G.8032 profile. Multiple ERP instances can be
associated with the same G.8032 profile.
Example
This example shows how to associate the profile “campus” with instance 1.
Switch# configure terminal
Switch(config)# ethernet ring g8032 ring1
Switch(config-erp)# instance 1
Switch(config-erp-instance)# profile campus
Switch(config-erp-instance)#
11-9 port0
This command is used to specify the first ring port of a physical ring. Use the no form of this command to
remove the settings.
port0 interface INTERFACE-ID
no port0
Parameters
PROFILE-NAME
Specifies the profile name to be associated with the ERP instance.
Default
None.