D-Link DKVM-IP1 - Serial Port

4.5.5 Serial Port
The DKVM-IP1 Serial Settings allows you to specify what device is connected to the serial
port and how it should be used.
Above: Click Device Settings > Serial Port to get this setup screen.
To configure the serial port’s settings, click Device Settings > Serial Port to open the
Serial Port Settings screen. The parameter descriptions are as follows:
Configuration login
If this is selected, the DKVM-IP1 will not use the serial port for any advanced functions; it
will only be used for initial configuration.
Modem
If this is selected, the serial port will support an Internet modem connection. The
DKVM-IP1 offers remote access using a telephone line in addition to the standard built-in
Ethernet adapter. The modem needs to be connected to the serial interface of the
DKVM-IP1.
100