1.8 When the server is up and running (Capabilities)
The DKVM-IP1 gives the user of the Remote computer full control over devices that are
connected to the DKVM-IP1 on the Host side. These connected devices could be single
computers or servers, or multiple computers or servers that are connected to the
DKVM-IP1 through a KVM Switch. The DKVM-IP1 comes pre-loaded with
web-management firmware (GUI) that allows a Remote-side administrator to manage the
settings of the DKVM-IP1 via the Internet. The firmware also allows the Remote-side
user to control the keyboard and mouse input of the Host system, as well as view the
video output of the Host computer/server that is connected to the DKVM-IP1. In addition,
it allows the Remote-side user to send special commands to the Host, and it lets the
Remote-side user perform periodic maintenance of the Host. From the Host Console
window on the Remote computer, you can do the following:
Reboot the Host system
Monitor the Host’s boot process
Boot the Host system from a separate partition to load the diagnostic environment
Run special diagnostic programs on the Host system
13
To Next Page
Loading...
