Using the PS Software
D-Link DPR-1020 - User Manual 28
Installing and Using a MFP/GDI Printer
This section will tell you how to use a MFP/GDI printer through the PS-Link utility
after the printer manufacturer’s driver has already been installed.
For PCs with the MFP/GDI printer driver installed:
If your computer already has the MFP/ GDI printer driver installed, you can just click
the [Link] button in PS-Link to complete the connection between the printer and
your computer.
For PCs without the MFP/GDI printer driver installed:
If your computer does not have the MFP/GDI printer driver installed, you may use
the following procedure:
1. Insert the manufacturer’s CD-ROM into your computer’s CD-ROM drive to initiate
the auto-run program.
2. Follow the instructions of the manufacturer’s CD-ROM to install the MFP driver
and other software until you are requested to attach the printer’s USB cable to your
computer.
3. The installation steps will be different depending on the printer and manufacturer
brand. Below you will find diagrams for several printers from different manufacturers:
To Next Page
Loading...
