Using the Web Configurator
D-Link DPR-1020 - User Manual 59
SETUP > LAN Setup
The LAN Setup screen allows you configure the MFP server’s local network settings.
Please note that this section is optional and you should not need to change any of
the settings here to get the MFP server up and running.
TCP/IP
These fields allow you to assign an IP address automatically or manually. When
clicking Manually Assign, you should enter the following information in the boxes:
IP Address, Subnet Mask, and Default Gateway.
If you have made changes click Apply Settings to save them or click Cancel to exit.
To Next Page
Loading...
