EasyManuals Logo

D-Link DSL-2750E User Manual

D-Link DSL-2750E
103 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
DSL-2750E User Manual
82
Wan Interface Choose a WAN interface used for the tunnel.
Lan Interface Choose a LAN interface used for the tunnel.
Click Apply to enable the settings.
Click Add below the table IPv6 Rapid Deployment to add a 6RD item, which is a
6in4 tunnel. The page shown in the following figure appears.
The following table describes the parameters of this page.
Field Description
Mechanism The tunnel type is 6RD, which is a 6in4 tunnel.
Dynamic Set the obtaining mode of Border Relay Address. You
may choose
0
or
1
.
IPv4MaskLen Set the subnet mask digits of the IPv4 address of the
local WAN interface.
Prefix Set the IPv6 prefix of the 6RD tunnel.
BorderRelayAddress Set the Border Relay IPv4 address at the remote end.
Click Apply to enable the settings.
3.3.19 Logout
Choose ADVANCED > Logout. The page shown in the following figure appears.
In this page, you can log out of the configuration page.

Other manuals for D-Link DSL-2750E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DSL-2750E and is the answer not in the manual?

D-Link DSL-2750E Specifications

ADSL Standards IconADSL Standards
G.dmt full rate downstreamup to 8 Mbps
G.dmt full rate upstreamup to 1 Mbps
G.lite ADSL downstreamup to 1.5 Mbps
G.lite ADSL upstreamup to 512 Kbps
G.dmt.bis full rate downstreamup to 12 Mbps
G.dmt.bis full rate upstreamup to 12 Mbps
ADSL full rate downstreamup to 24 Mbps
ADSL full rate upstreamup to 1 Mbps
Media Interface IconMedia Interface
ADSL interfaceRJ-11 connector for connection to 24/26 AWG twisted pair telephone line
LAN interfaceRJ-45 port for 10/100BASE-T Ethernet connection

Related product manuals