DSL-2750E User Manual
88
In this page, you can enable or disable the services that are used by the remote
host. For example, if telnet service is enabled and port is 23, the remote host can
access the device by telnet through port 23. Normally, you need not change the
settings.
Select the management services that you want to enable or disable on the LAN
or WAN interface. Click Apply to apply the settings.
Note:
If you disable HTTP service, you cannot access the configuration
page of the device any more.
3.4.4.3 IP Address
In the Access Controls page, click IP Address. The page shown in the following
figure appears.
To Next Page
Loading...
