D-Link DSL-2760U USER’S MANUAL
Tick the Enable Access Control Mode check box to allow the IP addresses
listed in the table below to access the local management.
Enter the IP Address in the field and click the Apply button to see the IP
address displays in the table below.
Tick the corresponding check box in the table and click the Remove button
to delete the IP address.
Click the Apply button to take effect.
Update Software
On this page the user can update the firmware of the router by simply download the latest firmware file and uploading it through this page. It’s important to keep
the router up to date with the latest firmware to prevent future problems.
Obtain an updated software image file from your ISP. Enter the path to the
image file location in the box below, or click the Browse button to locate the
image file. Click the Update Software button once to upload the new image
file.
NOTE: The update process takes about 2 minutes to complete, and your
DSL Router will reboot.
To Next Page
Loading...
Need help?
General
