D-Link DSL-2760U

D-Link DSL-2760U USER’S MANUAL
119
Statically assign an IP Address
If you are not using a DHCP capable gateway/router, or you need to assign a
static IP address, please follow the steps below:
Step 1
Windows® XP - Click Start > Control Panel > Network Connections.
Windows® 2000 - From the desktop, right-click My Network Places >
Properties.
Step 2
Right-click Local Area Connection which represents your D-Link network
adapter and select Properties.
Step 3
Select Internet Protocol (TCP/IP) in the list and click the Properties button.
Step 4
Click the Use the following IP address and enter an IP address that is on the same subnet as your network or the LAN IP address on your router.
Example: If the router’s LAN IP address is 192.168.1.1, make your IP address 192.168.1.X where X is a number between 2 and 99. Make sure that the number
you choose is not in use on the network. Set Default Gateway the same as the LAN IP address of your router (192.168.1.1).
Set Primary DNS the same as the LAN IP address of your router (192.168.1.1). The Secondary DNS is not needed or you may enter a DNS server from your ISP.
Step 5
Click OK twice to save your settings.