D-Link DVG-5802S - Application Rules

33D-Link DVG-5802S User Manual
Section 3 - Conguration
Enter a name for the rule. You may select a
pre-dened application from the drop-down
menu and click <<.
This is the port used to trigger the application. It
can be either a single port or a range of ports.
Select the protocol of the trigger port (TCP,
UDP, or Both).
This is the port number on the Internet side that
will be used to access the application. You may
dene a single port or a range of ports. You
can use a comma to add multiple ports or port
ranges.
Select the protocol of the rewall port (TCP,
UDP, or Both).
The schedule of time when the Application Rule
will be enabled. The schedule may be set to
Always, which will allow the particular service
to always be enabled. You can create your own
times in the Tools > Schedules section.
Name:
Trigger:
Trafc Type:
Firewall:
Trafc Type:
Schedule:
Application Rules
Some applications require multiple connections, such as Internet gaming, video conferencing, Internet telephony and
others. These applications have difculties working through NAT (Network Address Translation). Special Applications
makes some of these applications work with the DVG-5802S. If you need to run applications that require multiple
connections, specify the port normally associated with an application in the “Trigger Port” eld, select the protocol type
as TCP or UDP, then enter the rewall (public) ports associated with the trigger port to open them for inbound trafc.
The DVG-5802S provides some predened applications in the table on the bottom of the web page. Select the application
you want to use and enable it.
DVG-5802S