D-Link DVG-5802S - Administrator Settings; Remote Management

52D-Link DVG-5802S User Manual
Section 3 - Conguration
Enter a new password for the Administrator Login Name. The
administrator can make changes to the settings.
Enter the new password for the User login. If you login as
the User, you can only see the settings, but cannot change
them.
Enter a name for the DVG-5802S router.
Enable HTTPS server for web security log in.
Remote management allows the DVG-5802S to be congured
from the Internet by a web browser. A username and
password is still required to access the Web-Management
interface. In general, only a member of your network can
browse the built-in web pages to perform Administrator tasks.
This feature enables you to perform Administrator tasks from
the remote (Internet) host.
The port number used to access the DVG-5802S.
Example: http://x.x.x.x:8080 whereas x.x.x.x is the Internet
IP address of the DVG-5802S and 8080 is the port used for
the Web Management interface.
Click it once Enable Remote Management for external
access.
This section will list any rules that are created. You may click the Edit icon to change the settings or enable/disable the rule,
or click the Delete icon to remove the rule.
Admin
Password:
User Password:
Gateway Name:
Enable HTTPS
Server:
Remote
Management:
Remote Admin
Port:
Use HTTPS:
Inbound Filter:
Administrator Settings
This page will allow you to change the Administrator and User passwords. You can also enable Remote Management.
There are two accounts that can access the management interface through the web browser. The accounts are admin
and user. Admin has read/write access while user has read-only access. User can only view the settings but cannot
make any changes. Only the admin account has the ability to change both admin and user account passwords.
DVG-5802S