D-Link DVG-5802S - Syslog

54D-Link DVG-5802S User Manual
Section 3 - Conguration
SysLog
The Broadband Router keeps a running log of events and activities occurring on the Router. You may send these logs
to a SysLog server on your network.
Enable Logging
to SysLog
Server:
SysLog Server:
Check this box to send the router logs to a
SysLog Server.
The IP Address and Port of the SysLog server
that will be used to send the logs.
DVG-5802S
It is followed up the RFC3164. The Facilities and Severities of the messages are numerically coded with decimal values. Some of the
operating system daemons and processes have been assigned Facility values. Processes and daemons that have not been explicitly
assigned a Facility may use any of the “local use” facilities or they may use the “user-level” Facility. Those Facilities that have been
designated are with their numerical code values.
Syslog Level:
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions Critical: critical conditionsCritical: critical conditions
3 Error: error conditions
4 Warning: warning conditions
5 Notice: normal but signicant condition
6 Informational: informational messages
7 Debug: debug-level messages.
Syslog Facility:
Numerical Facility Code
0 kernel messages kernel messageskernel messages
1 user-level messages user-level messagesuser-level messages
2 mail system mail systemmail system
3 system daemons system daemonssystem daemons
4 security/authorization messages (note 1) security/authorization messages (note 1)security/authorization messages (note 1)
5 messages generated internally by syslogd messages generated internally by syslogdmessages generated internally by syslogd
6 line printer subsystem line printer subsystemline printer subsystem
7 network news subsystem network news subsystemnetwork news subsystem
8 UUCP subsystem UUCP subsystemUUCP subsystem
9 clock daemon (note 2) clock daemon (note 2)clock daemon (note 2)
10 security/authorization messages (note 1) security/authorization messages (note 1)security/authorization messages (note 1)
11 FTP daemon FTP daemonFTP daemon
12 NTP subsystem
13 log audit (note 1)
14 log alert (note 1)
15 clock daemon (note 2)
16 local use 0 (local0)
17 local use 1 (local1)
18 local use 2 (local2)
19 local use 3 (local3)
20 local use 4 (local4)
21 local use 5 (local5)
22 local use 6 (local6)
23 local use 7 (local7)
Note 1 - Various operating systems have been
found to utilize Facilities 4, 10, 13 and 14 for
security/authorization, audit, and alert messages
which seem to be similar.
Note 2 - Various operating systems have been
found to utilize both Facilities 9 and 15 for clock
(cron/at) messages.