DVG-N5412SP User’s Manual VoIP Router Configuration-IVR
D-Link Systems, Inc. 106
Once the setting or query has been completed, you can hear a dial tone. Use the same procedure to make
a second query or setting. To exit IVR mode, simply hang up the phone.
Example: enter “**#”
(you are now in IVR mode)Æ enter 101 (to query the current IP address) Æ the
system responds with an IP address. You can continue with more settings or queries: enter 111
(to set a
new IP address) Æenter 192*168*1*2
(new IP address).
Save Settings
When all setting procedures are completed, dial 509
(Save Settings) from phone keypad. Wait for about
three seconds, you should hear a voice prompt “1 (one).” You can now hang up the phone and please
reboot the VoIP Router to enable the new settings.
To inquire about the current VoIP Router WAN Port IP address setting
After completing all your settings, dial 101
from the keypad, then you can hear the system play back the
current WAN Port IP address. If the system does not play back the IP address after dialing 101
, this
indicates that the VoIP Router currently is not connected to the Internet. Please check and make sure the
cable connections, account numbers, and passwords are correct.
To Next Page
Loading...
Need help?
General
