D-Link DWL-2100AP - Configuration Procedures; Web Configuration Utility Guide

802.11 b/g Access Point Command Line Interface Manual
8
4
ETHERNET COMMANDS
Get Command: Function Syntax
get hostipaddr Display Host IP Address get hostipaddr
get ipaddr Display IP Address get ipaddr
get ipmask Display IP Network/Subnet Mask get ipmask
get gateway Display Gateway IP Address get gateway
get lcp Display Link Integrate state get lcp
get lcplink Display Ethernet Link State get lcplink
get dhcpc Display DHCP Client State of enabled or disabled get dhcpc
Set Command: Function Syntax
set ipaddr Set IP Address
set ipaddr <xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set ipmask Set IP Network/Subnet Mask
set ipmask < xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is Network mask
set gateway Set Gateway IP Address
set gateway <xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is Gateway IP address
set dhcpc Set DHCP Clinet State of enable or disabled
set dhcpc [0:1]
Explanation: 0=disable:1=enable