D-Link DWL-2100AP Command Line Interface Reference Manual

802.11 b/g Access Point Command Line Interface Manual
7
3
UTILITY COMMANDS
Help Command: Function Syntax
help Display CLI Command List help or ?
Ping Command: Function Syntax
ping Ping ping <xxx.xxx.xxx.xxx>
Restart and Exit Commands: Function Syntax
set factorydefault Restore to Default Factory Settings set factorydefault
reboot
Reboot Access Point. It is necessary to reboot the AP after making
configuration changes for those changes to take effect.
reboot
quit Logoff quit
Version Display Command: Function Syntax
version Displays the currently loaded firmware version version
System Status Command: Function Syntax
get cpuloadlimit Get CPU Load Limit get cpuloadlimit
get cpuloadperiod Get CPU Load Period get cpuloadperiod
set cpuloadlimit Set CPU Load Limit set cpuloadlimit [0-100]
set cpuloadperiod Set CPU Load Period set cpuloadperiod [0-100]
Addminstration Command: Function Syntax
get login Display Login User Name get login
get uptime Display UpTime get uptime
set login Modify Login User Name set login <username>
set password Modify Password set password
get systemname Display Access Point System Name get systemname
set systemname Specify Access Point System Name set systemname <name>

D-Link DWL-2100AP Specifications

General

Frequency Band	2.4 GHz
Data Transfer Rate	54 Mbps
Security	WEP, WPA, WPA2
LAN Port	1 x 10/100Base-TX (RJ-45)
Device Type	Wireless Access Point
Form Factor	External
Data Link Protocol	IEEE 802.11b, IEEE 802.11g
Antenna Qty	1
Interface	1 x 10Base-T/100Base-TX - RJ-45
Power Supply	External power adapter
Wireless Standard	IEEE 802.11b/g
Antenna	Detachable
Compliant Standards	IEEE 802.11b, IEEE 802.11g
Encryption Algorithm	WEP, WPA, WPA2
Authentication Method	RADIUS
Features	MAC address filtering
Operating Modes	Access Point, Repeater